Show Hidden Files is not working / or its Radio Button Disappeared

Are you facing the problem of Show hidden Files and Folders is not working or even there is no option of Show hidden files and folders in your folder options?

This problem is ususally caused by Viruses. If you select the radio button “Show hidden files and folders” and then press Ok. The changes would just disappear upon opening the dialog again. It was probably some virus attack after which the Windows registry was not being updated properly. So here is what methods to restore it back. Three methods are given below, so If one method is not working, please try another one.

Method 1:

Go to registry editor by running regedit in the run box.

TSHOOT (642-832) Practice in gns3

Here is the snaps of topology, which i prepared in gns3 to practice for real TSHOOT Exam TTs. Download the toplogy configuration files and practice as much that you memorise the toplogy and its configurations. It will be more helpful that you prepare your own topology in gns3 by seeing the toplogy diagrams given by Cisco or the one given below preapred by me...

TSHOOT Exam Topologies

Following three are the Cisco Tshoot Exam (642-832) Topologies. These same topologies are in the exam and most of the IP addresses were also same. 

Pass Tshoot, (Tshoot, 642-832 Dumps)

Alhamdullillah I passed TSHOOT on 9th OCT-2010 and Completed CCNP Certification.

I scored 1000/1000, and here is my Exam Experience.

There were Tweleve Trouble Tickets (TTs) and One Drag and Drops and Two MCQs.

I am listing down all the Links of these question and other Important TSHOOT related Links here

Do not forget to leave comments where you find that you can add some valueable information or your exam experience to help others and correct me at the appropriate posts.. 

TSHOOT, Trouble Tickets (TTs)

TSHOOT Exams Trouble Tickes (TTs) are 12 and are as follows...

1. Client is unable to ping R1’s serial interface from the client.

Problem

MD5 Authentication was not configured properly on R1.

TSHOOT:

Ans1) R1

Ans2) ipv4 OSPF

Ans3) ip ospf authentication message-digest command must be given on s0/0/0

2. R1 is not able to ping 209.65.200.226.

Problem

Wrong BGP Neighbor IP Address configured under “Router BGP 65001”

TSHOOT:

Ans1) R1

Ans2) BGP

Ans3) delete the wrong neighbor statement and enter the correct neighbor address in the neighbor command (change 209.56.200.226 to 209.65.200.226)

Why Track HSRP

Years ago, HSRP was very useful for providing failover, but it had some pretty serious drawbacks; it would only fail over if the LAN interface failed, or if the whole router failed. It would not fail over if the WAN interface went down, or if the routing got mixed up, etc. So Cisco added the ability to track interfaces with the standby command.